Learn these few tips, laser cutting time and material saving?

2023-04-20

When importing external graphics, the software will automatically optimize the graphics. If you need to manually optimize the graphics, you can use the "Optimize" button under the common menu bar, as shown in the following figure:

Select the graph you want to process, click the corresponding button, and then follow the prompts.

curve smoothing

Select the multisegment line that you want to optimize and click"

"Curve smoothing" button, the dialog box displays prompt input curve smoothing

Precision: Directly enter the desired fitting precision and press enter.

The figure on the right shows the comparison between the original curve and the smoothed curve. In order to observe the effect, the fitting precision is entered here

The value is large, the actual use of users according to their own needs for machining accuracy to fit

平滑前                                                           平滑后

segmentation

Curve segmentation is to break the closed graph into two graphs, and the user can edit the two graphs respectively.

Click"

"Button, click the location where you want to split. Curve segmentation process can be continuous, straight

Go to ESC to cancel a command or switch to another command.

• Remove small figure

Sometimes imported graphics may contain visually-imperceptible graphics, resulting in small display sizes, or processing

When moving to an abnormal location. You can remove this type of figure by using the Remove Minimal Figure feature. Click on the toolbar

"Remove Small Figure" button, set the figure size range, and then OK. Graphics smaller than this size will be deleted, others

The graph is preserved.

• Removal of duplicate lines

This function is used to eliminate visually overlapping graphics to leave only one, click "Remove duplicate lines", will be on all

Graphics are searched and cleaned.

• Merging line

Graphics drawn using AutoCAD often contain graphics that are visually connected, but not actually connected, by merging

The connecting line can merge them. Select the graphics you want to merge, and then click

", input merge precision,

Yes.

Note that the visual end point of the figure is not necessarily the geometric end point of the figure, and there may be superfluous primitives at the end point

To return the line, these graphs need to be split through the "curve split" first, to remove the excess graphs, and then merged.

Cut up 

For "internal mold" graphics, the shredding function can be used to generate shredding lines to prevent the scrap from warping and affecting processing. Cut thread to

White display, distinguish normal cut graphics.

• Splice cutter (split drawing)

For a drawing, in order to fit the machine tool, it can be divided into several parts cut. Divided drawings need to be kept separately.

Displayed with a red border

view

The view module can adjust the zoom, display position, and ordering of graphics, and can also edit graphics. The functional entrance is located at

On the left toolbar, select, edit nodes, sort manually, pan view, and zoom from top to bottom.

Node Editor

CypCut provides a node editing mode for fine tuning graphics. Select Edit Node

"Reselect

Graph, you can see the distribution of graph nodes. Drag a node (the yellow and blue rectangles shown below)

Adjust the figure. Click "Select" again

• Yellow is the node and the starting point, blue is the node, both of which can be dragged